Support for SDX1000
- Can the Cutting mat or Scanning mat for the ScanNCut (CM series) be used in the ScanNCut DX (SDX series)?
- Can different types of material be attached to the same mat for cutting?
- Mat, Cutting Blade and Material Combinations
- If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
- Troubleshooting about the Mat
- Can rough material be cut?
- Can multiple sheets of material be overlapped and attached to the mat? Show More Show Less
- When the mat is inserted, the attached material peels off.
- Mat, Cutting Blade and Material Combinations
- If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
- The mat is fed in at an angle.
- The mat cannot be inserted.
- The mat cannot be fed out.
- The material to be cut/drawn or original to be scanned cannot be attached to the mat.
- The mat cannot be recognized.
- Troubleshooting about the Mat Show More Show Less
Other FAQs Category
A guide to navigating our most common questions